Filter
Top Products
CAUTION:
The covers are to be closed at all times except for service by trained service personnel.
(
SPSFC003
)
CAUTION:
When the unit is being serviced, the covers should not be left off or opened while the machine is
running unattended. (
SPSFC004
)
CAUTION:
Due to weight of each thin node (under 18 Kg [40 lbs]), use care when removing and replacing thin
nodes above shoulder height. (
SPSFC005
)
CAUTION:
The wide node weight may exceed 32 Kg (70.5 lbs). (
SPSFC006
)
CAUTION:
Do not open more than one wide node or switch assembly drawer at a time. (
SPSFC007
)
CAUTION:
Make sure the stability foot and wheel chocks are installed on the frame. These are required to
maintain frame balance and position during service operations. (
SPSFC008
)
CAUTION:
Outer edges of chassis may be sharp. Care must be taken when removing and installing chassis.
(
SPSFC009
)
CAUTION:
The ground strip may have sharp edges. (
SPSFC010
)
CAUTION:
Do not remove wide nodes or switch assemblies from the mounting slides. Caution must be
observed when working with mounting slides to prevent pinched fingers or accidental release of
the unit. (
SPSFC011
)
CAUTION:
Do not remove the drawer case mounting screws at the bottom of both sides. (
SPSFC012
)
CAUTION:
Once the latch is released, push the drawer closed. Do not pull, as the drawer may disengage from
the rails, creating a safety hazard. (
SPSFC013
)
CAUTION:
Due to the weight of each wide node, use care when sliding and closing wide processor nodes
above shoulder height. (
SPSFC014
)
xii RS/6000 SP: SP Switch Service Guide