Filter
Top Products
Chapter 2 Configuration Tools
22
The procedure for changing any of the parameters is the same. The
procedure for changing the IP Address is given here as an example. Use
the same procedure for the other required parameters. To change the IP
Address parameter:
1. Power on the printer.
2. Press STOP to get to NOT READY state.
3. Press Menu to display OPERATOR MENU.
4. Press Scroll until ETHERNET PARAMETERS is displayed, then
press Enter.
5. Press Enter again then Scroll to choose an IP address octet to
change, then press Enter.
6. Press Scroll to choose the desired value for the octet, then press
Enter. The new value is shown with an asterisk. Press Return.
7. Repeat steps 5 through 6 until all IP address octets are set to the
desired value.
8. Press Return until ETHERNET PARAMETERS is on the first display
line.
9. Press Scroll to choose other IP parameters to change, then follow
the above steps for these as well.
10. When finished, press Return multiple times until NOT READY is
displayed.
11. Press Start.
12. Wait for “ETHERNET ADAPTER IS READY” message to display.
IMPORTANT
When a change is made from the operator panel, the Ethernet
Interface is re-initialized. The messages "ETHERNET ADAPTER IS
BEING RESET" and "ETHERNET ADAPTER IS BEING INITIALIZED"
display on the operator panel. This process takes several minutes.
Make sure not to shut the printer off or make further changes to the
Ethernet Interface settings during this initialization period to prevent
a loss of Ethernet Interface configuration information. When the
initialization is complete, the message "ETHERNET ADAPTER IS
READY" is displayed.