Filter
Top Products
Web Browser/HTTP Problem
93
13. Set the IP address, subnet mask, and default gateway parameters to
the desired values. (see “Configuration Tools” on page 21).
Web Browser/HTTP Problem
In some cases you may not be able to browse the printer web page
simply because the Ethernet Interface HTTP may be turned off.
If you can not “
ping
” the Ethernet Interface IP address, make sure the IP
Address, subnet mask, and default gateway are set correctly by checking
the Ethernet Parameters menu from the operator panel. See the
Setup
Guide
for configuration menu information.
If you can “
ping
” the Ethernet Interface IP address but can not access
the web pages, perform the following procedure to verify the Ethernet
Interface HTTP is turned on.
1. Telnet into the Ethernet Interface and log in as root with no password.
2. At the system prompt enter the following commands:
config http on
save
reset
3. After approximately 5 minutes, point your browser to the Ethernet
Interface IP address. The printer web pages should now be
accessible.
If you are still experiencing difficulty accessing or browsing the printer,
contact technical support for further assistance.