Filter
Top Products
Chapter 4 Configuring the AS/400 for Printing
44
3. Enter values for the following parameters:
Output queue (OUTQ)
The name of the AS/400 output queue. The name can be anything you
would like. This name is not the same as the printer internal queue name,
‘d1prn’.
NOTE: When the IPDS feature is installed, queue name ‘d4prn’ is not
available.
Remote system (RMTSYS)
Internet address of the NIC on the printer (*INTNETADR prompts you for
this) of the hostname of the NIC.
Remote printer queue (RMTPRTQ)
Default name of the IBM network printer. Set for any of ‘d1prn’ through
‘d4prn’. The remote printer queue name must be all lower case, entered
in single quotes.
NOTE: When the IPDS feature is installed, queue name ‘d4prn’ is not
available.
Writer to Autostart (AUTOSRTWTR)
Set the value to 1. This will start the Remote Writer when the queue is
created, and it is automatically starts the Remote Writer after each IPL of
the AS/400 and whenever STRTCP is started.
Connection type (CNNTYPE)
Specify this value as *IP.
Destination type (DESTTYP)
Specify XAUTOQ XAIX. XAUTOQ is a performance enhancement, in
which data is not required to be transformed again if the connection is
interrupted. XAIX allows printing of multiple copies.
Transform (TRANSFORM)
Specify this value as *YES.