Filter
Top Products
Chapter 13 Complete Command List
162
store tcpip
ifnum
frametype [[-]ethernet2]
[[-]802.2snap]
store tcpip 1 frametype ethernet2 802.2snap
Control which frame type(s) is supported with the TCP/IP protocol. By
default, both Ethernet 2 and 802.2snap are enabled but normal TCP/
IP communications rely on Ethernet 2. This setting has no affect on
other supported network protocols (e.g. Novell).
store tcpip route add|del host|net
IPaddress ifnum
store tcpip route add net 192.75.12.0 1
store tcpip route del net 192.75.12.9 1
Add or delete a static route to a particular TCP/IP host or subnet
specified by
IPaddress
so the Ethernet Interface knows how to
communicate with it. Normally one entry for a default router/gateway
is all that is needed for communications between different subnets.
Please see the next command for details.
store tcpip route add|del default
routerIPaddress
ifnum
store tcpip route add default 192.75.11.1 1
Store a default router/gateway defined by
routerIPaddress
so the
Ethernet Interface knows where to direct packets destined for another
subnet. It is easier to store one default entry rather than an entry per
remote host or network as in the previous command.
store tcpip tcp rxwin
packets
store tcpip tcp rxwin 2
Determine the receive window size for the Ethernet Interface. Usually
the
packets
value ranges from 2 to 8 with the lower number allowing
for more simultaneous TCP connections with the print server.