Filter
Top Products
Configuring PSF/400 for IPDS on V3R2
59
Activate release timer (ACTRLSTMR)
Specifies the point at which the release timer (RLSTMR) is activated. Set
to *NORDYF. This means that the release timer is activated when there
are no spooled files in the printer’s output queue with a status of RDY and
the last page of the last spooled file processed has printed. *NORDYF is
used so that all files with a status of RDY are printed before releasing the
session (which does not terminate the writer, however).
Release timer (RLSTMR)
Specifies the amount of time to wait before a session or dialog is released
without terminating the writer. The ACTRLSTMR parameter specifies
when this timer is to be activated. Set the parameter to a value at least
equal to the TIMEOUT value on the printer. IBM recommends *SEC15.
Remote Location name or address (RMTLOCNAME)
Enter the IP address or hostname of the printer.
TCP/IP port (PORT)
Specify 5001.
TCP/IP activation time (ACTTMR)
This value specifies the number of seconds that PSF/400 waits for a
printer to respond to an activation request. If only one system is using the
printer, use the default value (170 seconds). If more than one system is
using the printer, specify *NOMAX, which causes PSF/400 to wait
indefinitely for a response to an activation request.