Filter
Top Products
set Commands
169
set sysinfo loginfo [-]sys | [-]tcp | [-]ipx | [-]spx
set sysinfo loginfo -sys ipx
Set the Ethernet Interface debugging information type. Usually this
information includes unexpected errors or exceptions from the print
server divided into these groups:
sys General system messages.
tcp TCP stack messages.
ipx IPX stack messages.
spx SPX stack messages.
NOTE: This is not printer or job logging information.
set sysinfo logport null|syslog
set sysinfo logport null
Define where the debugging information should be sent to. This can
be sent to an output device off of the Ethernet Interface I/O port or to
a central TCP/IP host running a SYSLOG daemon. To set this host,
use the command “
set sysinfo syslog
hostIPaddress
”.
set sysinfo email
emailname@IPaddress
set sysinfo email joe@192.75.11.5
Define the user email address to receive printer and job logging
information from a particular logpath on the Ethernet Interface.
emailname
is the host or IP name of the user and
IPaddress
is the
IP address where the mail is stored on your network.
set sysinfo syslog
hostIPaddress
set sysinfo syslog 192.75.11.30
Set the IP address of the host running the SYSLOG daemon.
Ethernet Interface debugging or print job and printer logging
information can be sent to that IP address.
set sysinfo dns
DNSserverIPaddress
set sysinfo dns 192.75.11.2
Set your DNS server IP address so the Ethernet Interface can resolve
host names when used with its built-in Telnet and Ping clients.