Filter
Top Products
157
13 Commands
Command Shell Overview
The Ethernet Interface comes with an in-depth command shell called
“npsh.” It allows you to manipulate objects like destinations, I/O ports,
and models and provides monitoring and troubleshooting capabilities.
npsh Access Methods
There are many ways this command shell can be accessed:
• built in HTML forms
• a Telnet session from a TCP/IP host to the Ethernet Interface
• a single remote shell command (i.e. rsh, rcmd, remsh) from a TCP/IP
host
Main npsh Command Prefixes
All configurable commands either start with “store” or “set”,
troubleshooting commands usually start with “
debug”, and view
commands start with “
list”.
NOTE: If the “
store” prefix is used, the Ethernet Interface must be
repowered to make the changes take effect. Since “
store”
affects flash memory settings only, the print server must reset
and read the new settings now in flash memory.
NOTE: If the “
set” prefix is used, a “save” command must be executed
as well so that the new settings are retained after power cycles.
Since “
set” only affects the settings in memory, they will be lost
after a power cycle unless they are saved to flash memory.