Filter
Top Products
Chapter 8 Novell Host Configuration
122
NetWare Version 3.x RPRINTER Setup
These steps are for Novell environments with Netware 3.x (or earlier) file
servers.
To configure a new RPRINTER on a NetWare 3.x network:
1. Log in to the Ethernet Interface command shell, npsh, as root.
If you have TCP/IP available and this print server already has an IP
address stored within it, you can use the built-in HTML configuration
forms or a Telnet session. Please see “Configuration Tools” on
page 21 for further details. If you have only Novell available, you will
need to use a PC, laptop, or terminal.
NOTE: If you use HTML configuration, you will need to go to the
“Network Configuration” HTML form (i.e.
“
http://
EthernetInterfaceIPaddress
/
networkConf.html
”; e.g. “http://192.75.11.9/
networkConf.html
”) and look under the “Novell” section.
The settings in the following step are found there. If using a
Telnet session, you will need to manually execute the commands
listed in the next step.
2. Store the RPRINTER settings on the Ethernet Interface. This will
refer to an existing PSERVER.NLM on the file server or to one that
you will create later in these steps.
Syntax:
store rprinter add
PSERVERname printernumber
EthernetInterfacedestination
Example for an RPRINTER servicing printer 0 of the PSERVER.NLM
called
pserver1 and sending jobs to the Ethernet Interface destination
d1prn:
store rprinter add pserver1 0 d1prn
NOTE: When the IPDS feature is installed, queue name ‘d4prn’ is not
available.
3. Leave this Ethernet Interface login session and log on to the NetWare
3.x file server as Supervisor.