Filter
Top Products
Configuration Procedure
143
Figure 19. Sample PSFPROC procedure (continued)
NOTE: To specify a TCP/IP address space name other than the default,
TCPIP, code the following exec statement in the writer
procedure:
//STEP01 EXEC PGM=ASPPIEP,REGION=4096K, PARM=(,,,,
tcpip_name
)
where
tcpip_name
is the name of the TCP/IP address space. If
this parameter is not coded, PSF/MVS uses the default name,
TCPIP.
//* ***************************************************************************************** */
//PRT1 CNTL
//PRT1 PRINTDEV FONTDD=*.FONT300, /* 300 PEL FONT LIBRARY DD */
// OVLYDD=*.OLAY01, /* OVERLAY LIBRARY DD */
// PSEGDD=*.PSEG01, /* SEGMENT LIBRARY DD */
// PDEFDD=*.PDEF01, /* PAGEDEF LIBRARY DD */
// FDEFDD=*.FDEF01, /* FORMDEF LIBRARY DD */
// JOBHDR=*.JOBHDR, /* JOB HEADER SEPARATOR */
//* /* OUTPUT */
// JOBTRLR=*.JOBTLR, /* JOB TRAILER SEPARATOR */
//* /* OUTPUT */
// DSHDR=*.DSHDR, /* DATA SET HEADER */
//* /* SEPARATOR */
// MESSAGE=*.MSGDS, /* MESSAGE DATA SET OUTPUT */
// BUFNO=5, /* NUMBER OF WRITE DATA BUFFERS */
// PAGEDEF=A06462, /* DEVICE PAGEDEF DEFAULT */
// FORMDEF=A10110, /* DEVICE FORMDEF DEFAULT */
// CHARS=(GF10, /* DEVICE */
// GS10,TU10,GU10), /* DEFAULT FONT SET */
// PIMSG=YES, /* ACCUMULATE DATA SET */
//* /* MESSAGES */
// DATACK=BLOCK, /* REPORT ALL DATA-CHECK */
//* /* ERRORS */
// TRACE=NO, /* CREATE INTERNAL TRACE */
// FAILURE=WCONNECT, /* PSF ACTION ON PRINTER */
//* /* FAILURE */
// TIMEOUT=REDRIVE /* PSF ACTION ON TIMEOUT */
// MGMTMODE=OUTAVAIL, /* PRINTER MANAGEMENT MODE */
// DISCINTV=15, /* DISCONNECT INTERVAL IN */
//* /* SECONDS */
// IPADDR=’xxx.xxx.xxx.xxx’ /* IP ADDRESS FOR TCP/IP */
//PRT1 ENDCNTL