Filter
Top Products
TCP/IP Access Problem
113
For default destination model mappings of the Ethernet Interface, please
see “Ethernet Interface Naming Schemes” on page 183.
TCP/IP Access Problem
If you can “
ping
” the printer from a workstation, but you cannot Web
browse, Telnet, or print to the printer through the Ethernet Interface, there
may be an incorrect entry in the TCP access list. In order for this
workstation to use the Ethernet Interface in this case, one of two things
must happen.
1. The TCP list must have an entry added to grant access to this
workstation.
2. All entries must be deleted from the TCP list to grant all workstations/
hosts access to the above TCP services.
To view the current access list:
Use the printer operator panel to access the configuration menu (see the
Setup Guide
for configuration menu information). From the
DIAGNOSTICS/Printer Tests menu choose the Ethernet Test Page.
When the page prints, look under the “TCP ACCESS TABLE” section for
the TCP access list entries.
To add/delete a TCP access list entry, refer to “TCP Access Lists” on
page 179.
NOTE: When the following procedure is used, the TCP access list will be
cleared but all IP addresses will need to be entered again after
the procedure is complete.
To reset all TCP/IP values to the factory defaults when access is
impossible:
1. Obtain a printer configuration printout using the operator panel. See
the
Setup Guide
for configuration menu information.
2. Power off the printer.
3. On the Ethernet Interface, place SWITCH 2, the center switch, in the
down position.
4. Power on the printer and wait for the READY state.