Filter
Top Products
Chapter 13 Complete Command List
170
set sysinfo descramblekey
hexvalue
set sysinfo descramblekey 1234
Set the key value used for descrambling print jobs that have passed
through Printronix npscramble utility on a TCP/IP host. This key is a
four-digit hexadecimal value obtained from the host software,
npscramble. Within the npscramble source code, there is a variable
called SR_KEY which contains the default key value. This can be
changed to any four-digit value you would like.
set sysinfo module [[-]novell] [[-]netbios]
set sysinfo module -novell
Enable and disable certain network protocol stacks within the
Ethernet Interface. Sometimes it helps to disable any protocols you
are not using on your network.
set time
hours
[
minutes
[
seconds
]]
set time 10 30
Set the current time noting the
hours
based on the 24-hour system
and the
minutes
and
seconds
ranging from 0 through 59. If the
Ethernet Interface is reset, this value will be lost so you will need to
set the time again.
set user add|del
username
set user add eng
Add or remove a user on the Ethernet Interface defined by
username.
IMPORTANT
Be careful not to delete the root user, or you will be unable to
configure any further settings on the print server. You will have to
go back to factory defaults to correct this problem.
set user passwd
username password
set user passwd eng mplex1
Assign a
password
to a defined user on the Ethernet Interface. This
password
must be less than eleven characters.
set user type
username
root|guest
set user type eng root
Assign root or guest privileges to a particular user defined by
username
. Guest permissions allow viewing of settings only. Root
permissions allow complete control of the Ethernet Interface.