Filter
Top Products
Configuration Procedure
141
The value you specify for the PROC parameter must match the name on
the PSF/MVS Startup procedure.
JES3 Printer Definitions
Below is an example JES3 printer definition. This example is not
executable, but it is intended to help the JES3 systems programmer
define the printer to the MVS host.
FSSDEF,TYPE=WTR,FSSNAME=FSS1,PNAME=PSFPROC,SYSTEM=SYS1,TERM=NO
DEVICE,JNAME=PRT1,JUNIT=(,SYS1,,OFF),FSSNAME=FSS1,
MODE=FSS,PM=(LINE,PAGE,SOSI1),CHARS=(YES,GT12),
The value you specify for the JNAME parameter must match the name of
the printer in the PSF/MVS Startup procedure.
The value you specify for the PNAME parameter must match the name
on the PSF/MVS Startup procedure.
Define the Printer to PSF/MVS
Each TCP/IP-attached printer must be defined to PSF with a PRINTDEV
statement in the PSF/MVS startup procedure.
Figure 19 shows a sample PSFPROC procedure that you can modify to
suit your installation. The PRINTDEV statement shows the required
IPADDR keyword.
No 6400 printer-specific writer procedure is currently supplied by IBM.
You can, however, copy the APSWPROT sample from the APAR medium
and modify it for the IBM 6400 printer.
NOTE: The IBM 6400 printer supports only resident symbol sets.