Filter
Top Products
set Commands
165
netbios Windows 95 and Windows for Workgroups printing.
ftpd Printing using the File Transfer Protocol (FTP) via
TCP/IP.
set dest from default
Set all destination settings back to factory defaults.
set dest from stored
Set all current destination settings to the values stored in flash
memory.
set logpath
logpath
name
newname
set logpath l1 name pagecount
Change the current name of the
logpath
to a new name as indicated
by
newname
. This
newname
must be nine characters or less or it
will be truncated. These names are case sensitive.
set logpath
logpath
type [[-]job] [[-]user] [[-]pgcnt]
[[-]cksum] [[-]printer] [[-]ioport]
set logpath l2 type job user printer pgcnt
Establish the type of printer and print job logging to be done within
this logpath. The options are:
job Job ID, username, etc.
user User ID along with three messages per job about
start and finish.
pgcnt For total pages printed in a job.
cksum 16-bit checksum value to confirm integrity of data
printed.
printer For special printer feedback.
ioport Printer error messages determined through the
parallel port pins.
set logpath
logpath
port
TCPportnumber
| email|syslog
set logpath l3 port 2000
Determines where the log information should be sent for a print job or
attached printer. The choices are:
TCPportnumber
TCP port number ranging from 1024 to 65000.