Filter
Top Products
Chapter 13 Complete Command List
174
debug eeprom
List ROM contents.
debug nif
List network interface statistics.
Miscellaneous Commands
These commands do not fall under any specific section of the command
shell but they are used quite frequently.
save [default]
Save the current settings to flash memory so they are available after
power cycles. Sysinfo, destination, model, logpath, variable, user,
and I/O port settings will be saved. If
default is specified as well,
factory settings will be saved, overwriting any new settings you have
configured.
reset
Perform a warm boot or hardware reset simulating a power-on reset.
Restores current settings to those stored in flash memory since the
flash memory settings will be read and loaded into memory upon
bootup.
load [default]
Load the settings stored in flash memory and use them as the current
or working settings. If default is specified as well, factory settings will
be loaded.
lpstat [
ioport
] [
jobID
]
lpstat prn
Display active and queued jobs and I/O port status for a given
ioport
or
jobID
. Specifying one of these parameters will shorten the output
focusing on the particular I/O port or print job specified.
cancel
jobID
cancel d1prn-10
Remove a job from an I/O port queue. Use “lpstat” to find a
particular job ID first.