Filter
Top Products
set Commands
163
store tcpip tcp opts [-]keepalive [-]disbufmgmt
store tcpip tcp opts keepalive -disbufmgmt
Control whether the Ethernet Interface maintains a connection with a
host when data can not be accepted into its buffer. Normally the
keepalive feature is enabled so when the printer can not accept data,
the print job connection is maintained and continued once the
situation clears. If disbufmgmt is disabled (i.e. “-”), the Ethernet
Interface will not buffer any data when there is a blocked situation
with the printer. Normally it is best to have both keepalive and
disbufmgmt enabled.
store tcpip tcp access [root] add|del
IPaddress
store tcpip tcp access add 192.75.11.25
Add or remove an entry from the Ethernet Interface TCP access list
defined by
IPaddress
. If the list has an entry, only this host can print
to and remotely interact with the print server.
store tcpip proxy add|del
targetIPaddress
store tcpip from default
Set all TCP/IP network settings back to factory defaults.
store tcpip from current
Store all current TCP/IP network settings to flash memory so they are
retained after a power cycle. This ensures all current settings match
what is stored in flash memory.
set Commands
These settings alter the current or working settings in memory only.
Therefore, they will be lost if the Ethernet Interface is power cycled. To
ensure this does not happen, be sure to issue a “save” command so the
current settings get written to flash memory.
set date
year month day
set date 1997 02 10
Set the current date noting the four-digit year, the two-digit month
from 1 through 12, and the day being the number in the month. If the
Ethernet Interface is reset, this value will be lost so you will need to
set the date again.