Filter
Top Products
EonStor A16E-G2130-4 Installation and Hardware Reference Manual
17. Provide a soft, clean surface to place your enclosure on before working
on it. Servicing the enclosure on a rough surface may damage the finish
of the chassis.
18. If it is necessary to transport the subsystem, repackage all disk drives
separately.
19. If one of the following situations arises, get the enclosure checked by
service personnel:
a. Any of the power cords or plugs is damaged.
b. Liquid has penetrated into the subsystem.
c. The enclosure has been exposed to moisture.
d. The subsystem does not work well or you cannot get it work
according to this manual.
e. The subsystem has dropped and been damaged.
f. The subsystem shows obvious signs of breakage.
2.3.2 Static-free Installation
Static electricity can damage the system’s electronic components. To
prevent ESD damage to any of the components, follow these precautions
before touching or handling them:
Discharge the static electricity accumulated in your body by
wearing an anti-static wristband.
Use antistatic strap during handling. Connect the equipment end of
the strap to an unfinished chassis surface.
Avoid carpets, plastic, vinyl, and styrofoam in your work area.
If the need should arise for carrying subsystem modules from one
place to another, carry them in a static shielding container.
Avoid the contact between PCBs and clothing.
Handle all components by holding their edges or metal frames.
Avoid touching the exposed circuitry on PCB boards and connector
pins.
Safety Precautions
2-4