Filter
Top Products
EonStor A16E-G2130-4 Installation and Hardware Reference Manual
2. A BBU module has been charged for over twelve (12) hours. A timer is embedded
with the charger. When this occurs, the charger will enter a timer fault state. The
fault condition usually occurs with a brand new BBU or with a totally discharged
BBU. Charging will resume automatically if you remove and re-install the BBU
module.
5.4.1 BBU Warnings and Precautions
Install or replace the BBU with BBUs supplied by your EonStor vendors only.
Use of battery cells provided otherwise will void our warranty.
Always dispose of a replaced battery in an ecologically responsible manner.
Dispose of used BBUs at authorized battery disposal sites only.
Do not use nor leave the BBU near a heat source. Heat can melt the insulation
and damage other safety features of battery cells, possibly will cause acid leak
and result in flames or explosion.
Do not immerse the BBU in water nor allow it to get wet. Its protective features
can be damaged. Abnormal chemical reactions may occur, possibly cause
functional defects, acid leak, and other hazardous results.
Do not disassemble or modify the BBU. If disassembled, the BBU could leak
acid, overheat, emit smoke, burst and/or ignite.
Do not pierce the BBU with a sharp object, strike it with a hammer, step on it, or
throw it. These actions could damage or deform it and internal short-circuiting
can occur, possibly cause functional defects, acid leak, and other hazardous
results.
If a BBU leaks, gives off a bad odor, generates heat, becomes discolored or
deformed, or in any way appears abnormal during use, recharging or storage,
immediately remove it from the subsystem and stop using it. If this is discovered
when you first use the BBU, return it to Infortrend or your subsystem vendor.
5-10 Replacing a Faulty BBU