Filter
Top Products
Software Developer’s Manual 203
PHY Functionality and Features
Figure 11-5. 1000BASE-T Receive Flow
11.11.4 Receive Functions
This section describes function blocks that are used when the PHY receives data from the twisted
pair interface and passes it back to the MAC.
11.11.4.1 Hybrid
The hybrid subtracts the transmitted signal from the input signal, allowing the use of simple
100BASE-TX compatible magnetics.
11.11.4.2 Automatic Gain Control
The Automatic Gain Control (AGC) normalizes the amplitude of the received signal, adjusting for
the attenuation produced by the cable.
11.11.4.3 Timing Recovery
This function re-generates a receive clock from the incoming data stream which is used to sample
the data. On the Slave side of the link, this clock is also used to drive the transmitter.
11.11.4.4 Analog-to-Digital Converter
The Analog-to-Digital (ADC) function converts the incoming data stream from an analog
waveform to digitized samples for processing by the DSP core.
11.11.4.5 Digital Signal Processor
The Digital Signal Processor (DSP) provides per-channel adaptive filtering, which eliminates
various signal impairments including:
• Inter-symbol interference (equalization).
• Echo caused by impedance mismatch of the cable.
• Near-end crosstalk (NEXT) between adjacent channels (A, B, C, D).
D0
D1
D2
D3
D4
D5
D6
D7
GMII
8 bits
Polynomial
Descrambler
8 bits
DSP
PAM-5
Encoded Input
from 4-Pair UTP Line
Receiver