Filter
Top Products
Software Developer’s Manual 295
Register Descriptions
Note: The 82547GI/EI signals interrupts over the CSA port, not a dedicated interrupt pin.
13.4.18 Interrupt Throttling Register
1
ITR (000C4h; R/W)
Software can use this register to pace (or even out) the delivery of interrupts to the host CPU. This
register provides a guaranteed inter-interrupt delay between interrupts asserted by the Ethernet
controller, regardless of network traffic conditions. To independently validate configuration
settings, software can use the following algorithm to convert the inter-interrupt interval value to the
common interrupts/sec performance metric:
For example, if the interval is programmed to 500d, the Ethernet controller guarantees the CPU is
not interrupted by the Ethernet controller for 128
sec from the last interrupt. The maximum
observable interrupt rate from the Ethernet controller must never exceed 7813 interrupts/sec.
Inversely, inter-interrupt interval value can be calculated as:
The optimal performance setting for this register is very system and configuration specific. A
initial suggested range is 651-5580 (28Bh - 15CCh).
Reserved 31:17 0b
Reserved
Reads as 0b.
1. The 82540EP/EM, 82541xx, or 82547GI/EI do not support SerDes functionality.
2. Not applicable to the 82544GC/EI.
1. Not applicable to the 82544GC/EI.
Field Bit(s)
Initial
Value
Description
31 - 16 15 - 0
Reserved INTERVAL
Field Bit(s)
Initial
Value
Description
INTERVAL 15:0 0b
Minimum inter-interrupt interval. The interval is specified in 256 ns
increments. Setting this bit to 0b disables interrupt throttling logic.
Reserved 31:16 X Reserved. Should be written with 0b to ensure future compatibility.
interrupts/ ondsec 256
9–
10 interval
1–
=
inter-interrupt interval 256
9–
10 interrupts/sec
1–
=