Filter
Top Products
GD82559ER — Networkin
g
Silicon
30
Datasheet
Note that word 0Ah contains several configuration bits. Bits from word 0Ah, FBh through FEh,
and certain bits from word 0Dh are described as follows:
Note:
The IA read from the EEPROM is used by the 82559ER until an IA Setup command is issued by
software. The IA defined by the IA Setup command overrides the IA read from the EEPROM.
4.5 10/100 Mb
p
s CSMA/CD Unit
The 82559ER CSMA/CD unit implements both the IEEE 802.3 Ethernet 10 Mbps and IEEE
802.3u Fast Ethernet 100 Mbps standards. It performs all the CSMA/CD protocol functions such as
transmission, reception, collision handling, etc. The 82559ER CSMA/CD unit interfaces the
internal PHY unit through a standard Media Independent Interface (MII), as specified by IEEE
802.3, Chapter 22. This is a 10/100 Mbps mode in which the data stream is nibble-wide and the
serial clocks run at either 25 or 2.5 MHz.
Table 1. EEPROM Words Field Descri
p
tions
Word Bits Name Description
Word A
5:14 Si
g
nature The Si
g
nature field is a si
g
nature of 01b, indicatin
g
to the 82559ER that there is
a valid EEPROM present. If the Si
g
nature field is not 01b, the other bits are
i
g
nored and the default values are used.
13 Reserved Reserved Default value is 0b.
12 Reserved This bit is reserved and should be set to 0b.
11 Boot Disable The Boot Disable bit disables the Expansion ROM Base Address Re
g
ister
(
PCI
Confi
g
uration space, offset 30H
)
when it is set. Default value is 0b.
10:8 Revision ID These three bits are used as the three least si
g
nificant bits of the device
revision, if bits 15, 14, and 13 e
q
ual 011b and the ID was set as described in
Section 7.1.10, “PCI Subs
y
stem Vendor ID and Subs
y
stem ID Re
g
isters” on
pa
g
e53. The default value depends on the silicon revision.
7 Reserved Reserved and should be set to 0b
6 Deep Power
Down
This bit is used as the Deep Power Down enable/disable bit. When the DPD bit
e
q
uals 0b, deep power down is enabled in the D3 power state while PME is
disabled. If the DPD bit e
q
uals 1b, deep power down is disabled in the D3
power state while PME is disabled.
5 Reserved Reserved and should be set to 0b.
4:3 Reserved These are reserved and should be set to 00b.
2
1 Standb
y
Enable The Standb
y
Enable bit enables the 82559ER to enter standb
y
mode. When
this bit e
q
uals 1b, the 82559ER is able to reco
g
nize an idle state and can enter
standb
y
mode
(
some internal clocks are stopped for power savin
g
purposes
)
.
The 82559ER does not re
q
uire a PCI clock si
g
nal in standb
y
mode. If this bit
e
q
uals 0b, the idle reco
g
nition circuit is disabled and the 82559ER alwa
y
s
remains in an active state. Thus, the 82559ER will alwa
y
s re
q
uest PCI CLK
usin
g
the Clockrun mechanism.
0 Reserved Set this bit e
q
ual to 0b for compatibilit
y
.
D
11:8 Reserved Reserved.
7:0 Reserved
FBh -
FEh
ALL Reserved