Filter
Top Products
}
}
}
}
You verify your configuration on the MX Series router with the show l2circuit connections
command:
user@PE2>show l2circuit connections
Layer-2 Circuit Connections:
Legend for connection status (St)
EI -- encapsulation invalid NP -- interface h/w not present
MM -- mtu mismatch Dn -- down
EM -- encapsulation mismatch VC-Dn -- Virtual circuit Down
CM -- control-word mismatch Up -- operational
VM -- vlan id mismatch CF -- Call admission control failure
OL -- no outgoing label IB -- TDM incompatible bitrate
NC -- intf encaps not CCC/TCC TM -- TDM misconfiguration
BK -- Backup Connection ST -- Standby Connection
CB -- rcvd cell-bundle size bad XX -- unknown
SP -- Static Pseudowire
Legend for interface status
Up -- operational
Dn -- down
Neighbor: 10.255.171.45
Interface Type St Time last up # Up trans
ae0.0(vc 100) rmt Up May 12 14:48:58 2009 2
Remote PE: 10.255.171.45, Negotiated control-word: Yes (Null)
Incoming label: 299872, Outgoing label: 299824
Local interface: ae0.0, Status: Up, Encapsulation:VLAN Q-in-Q and VCI
Interworking
Configuring PE2 with a Remote Interface Switch
CE1 Configuation Configure Ethernet over ATM on the ATM interface
[edit]
interfaces {
at-2/0/0 {
encapsulation ethernet-over-atm;
atm-options {
vpi 100;
}
unit 0 {
vci 100.34;
family inet {
address 30.1.1.1/24;
}
}
}
}
PE1 Configuation Configure the Remote Interface Switch
[edit]
interfaces {
at-2/0/1 {
85Copyright © 2010, Juniper Networks, Inc.
Chapter 8: MX Series Router in an ATM Ethernet Interworking Function