Filter
Top Products
Table 3: Monitor Ethernet Delay Command Parameters (continued)
DescriptionParameter RangeParameter
(Optional)Specifiesthe numberof seconds to waitbetween frames. The
default is 1 second.
1–255 seconds
(default: 1)
wait time
If you attempt to monitor delays to a nonexistent MAC address, you must exit the
application manually using ^C:
user@host> monitor ethernetdelay-measurement two-way 00:11:22:33:44:55
Two-way ETH-DM request to 00:11:22:33:44:55, Interface ge-5/2/9.0
^C
--- Delay measurement statistics ---
Packets transmitted: 10, Valid packets received: 0
Average delay: 0 usec, Average delay variation: 0 usec
Best case delay: 0 usec, Worst case delay: 0 usec
Related
Documentation
MX Series Ethernet Services Routers Solutions Page•
• Ethernet Frame Delay Measurements on page 119
• Configuring MEP Interfaces to Support ETH-DM on page 122
• Viewing ETH-DM Statistics on page 124
• Configuring One-Way ETH-DM with Single-Tagged Interfaces on page 125
• Configuring Two-Way ETH-DM with Single-Tagged Interfaces on page 130
• Configuring ETH-DM with Untagged Interfaces on page 134
Viewing Ethernet Frame Delay Measurements Statistics
Once Ethernet frame delay measurement statistics have been collected, they can be
displayed.
To retrieve the last 100 Ethernet frame delay measurement statistics per remote MEP
or per CFM session, two types of show commands are provided:
•
For all OAM frame counters and Ethernet frame delay measurement statistics
•
For Ethernet frame delay measurement statistics only
To retrieve all Ethernet frame delay measurement statistics for a given session, use the
show oam ethernet connectivity-fault-management mep-statistics maintenance-domain
namemaintenance-associationname [local-mepidentifier][remote-mepidentifier][count
count] command.
To retrieve only Ethernet frame delay measurement statistics for a given session, use
the show oam ethernet connectivity-fault-management delay-statistics
maintenance-domain name maintenance-association name [local-mep identifier]
[remote-mep identifier] [count count] command.
Copyright © 2010, Juniper Networks, Inc.124
Junos 10.4 MX Series Ethernet Services Routers Solutions Guide