Filter
Top Products
M160 Internet Router Hardware Guide
Figure 12: LCD in Idle Mode
ENTER
MENU
1263
Router1
Up 2 + 11:59
Power OK
The lines in the display report the following information:
First line—Routing node name.
Second line—Length of time the router h as been running, reported in the
following form:
Up days + hours:minutes
Third and fourth lines—Status messages, which rotate at two-second intervals.
Some conditions, such as removal or insertion of a system component,
can interrupt the messages.
To add a message that alternates every 2 seconds with the default status
messages, use the
set chassis display message command. For more information,
see the JUNOS Internet Software Operational Mode Command Reference:
Protocols, Class of Service, Chassis, and Management.
LCD Alarm Mode
When a red or yellow alarm occurs, the LCD switches to alarm mode a nd
reports about the alarm condition, as shown in Figure 13.
Figure 13: LCD in Alarm Mode
ENTER
MENU
1264
Router1
2
R: PEM 1 Input Failure
Y: Change air filter
30 Craft Interface