Filter
Top Products
Maintenance
Cleaning / Replacing the Air Filters
CAUTION:
NOTE:
Let washed filters and filter mats dry well before reinstalling
them.
Do not wring, bend or press filters and filter mats.
Do not let filters and filter mats dry in the sun.
Below the Cutter Unit
1. Remove the cover (1).
2. Wash the filter mat in water. Replace the cutter unit air filter if it is too dirty.
3. Reinstall in the filter mat.
Observe the correct position. The smooth side should point to the grid.
4. Mount the cover.
Door to Print Engine
NOTE:
CAUTION:
The filter is mounted on the housing of the exposure gap fan on the inside of
the print engine door. The filter holder is fastened to the housing by 2 black
locking screws (1).
1. Loosen the locking screws (1) and remove the filter holder (2).
2. If the filter mat is not excessively dirty, wash it in warm water.
Do not bend or wring the filter mat. Broken fibers may be blown
into the print engine.
3. Remove all water and insert the dry filter in the filter holder.
4. If the air filter is extremely dirty, replace it.
5. Fasten the filter holder again.
KODAK PROFESSIONAL RP 30 Laser Printer 8-23