Filter
Top Products
Operator’s Guide
A water temperature of approximately 30°C (86°F) is recommended for the
preparation of the individual tank fillings.
The chemicals can be mixed directly in the machine tanks.
CAUTION: To prevent contamination of the chemistry, always fill the tanks
in the following order:
SB Ö BX Ö CD
Thoroughly rinse the containers used for the preparation with
cold water after each preparation of a solution.
CD
BX
SB1
SB2
SB3
SB4
Rinsing the Tanks
1. Open the paper processor cover.
2. Fill the replenisher tank with water until the lower level sensors are covered to
avoid the request for the connection of an EKTACOLOR Processing Cartridge.
3. Fill all machine tanks with hot water.
4. Let the equipment run for a short while to rinse the circulation system and
remove any chemical residues.
5. Switch off the equipment and completely drain the cleaning water. Check that all
drain valves are closed correctly.
6. Check the hose positioning. Make sure the hose has no:
• Leaks
• Sharp bends
• Crimps
• Air bubbles
3-4 KODAK PROFESSIONAL RP 30 Laser Printer