Filter
Top Products
104
Chapter 7: Solving printer problems
Print Jobs on Disk? Jobs that were spooled to the optional hard disk before the printer was last turned
off have not yet printed. Press
Go
to print the jobs. Press
Return
or
Stop
to delete
the jobs from the disk without printing them.
Files Will be Lost. Go/Stop? You have changed the Job Buffer Size setting from the operator panel, and the
printer must reformat the hard disk to activate the change. If you press
Go
, all files
currently stored on the disk will be deleted. Press
Return
or
Stop
to cancel this
operation.
Invalid Font Data The printer has detected an incompatibility between the font data and the
firmware. You must download compatible font data to flash memory before the
printer can return to the ready state.
Invalid Network
x
Code The code in the specified network adapter has not been programmed or is invalid.
You must download valid code to the network adapter before the printer can return
to the ready state.
30
color
Print Unit Missing The specified print unit (Cyan, Magenta, Yellow, or Black) is not installed in the
printer. Insert the print unit and close the top cover to clear the message.
33 Tray
x
Configuration Error The printer has detected a tray with the rear paper guide in the wrong position.
When loading A4 and letter size paper, make sure you place it in the tray with the
long-edge of the sheet next to the front of the tray. Position the rear paper guide
correctly for the paper size, then insert the tray in the printer.
35 Res Save Off
Deficient Memory
The printer lacks the memory needed to enable the Resource Save function. This
message usually indicates that too much memory is allocated for one or more of
the printer link buffers.
To disable Resource Save and continue printing, press
Go
.
To enable Resource Save after you get this message:
• Set the link buffer for each interface to Auto, then exit the menus to activate the
link buffer changes. When the
Ready
message is displayed, enable Resource
Save from the Setup Menu.
• Or, install additional printer memory. See page 66 for more information.
37 Insufficient Collation Area The printer memory (or optional hard disk, if installed) does not have the space
necessary to collate the print job.
•Press
Go
to print the portion of the job already stored and begin collating the
rest of the job.
• Cancel the print job. Press
Menu>
or
<Menu
. The Job Menu is displayed. Press
Menu>
or
<Menu
until Cancel Job appears on the second line. Press
Select
.
Attendance messages (continued)
Message Action