Filter
Top Products
31
Menus
Auto Continue Disabled*
5…255
Set Auto Continue to a value between 5 seconds and 255 seconds to have the printer
automatically continue operating after it detects one of the following errors:
35 Res Save Off Deficient Memory
37 Insufficient Collation Area
38 Memory Full
39 Complex Page
52 Flash Full
53 Unformatted Flash
54 Parallel Error
54 Parallel Option
x
Error
54 Serial Option
x
Error
54 Std Par ENA Connection Lost
54 Par
x
ENA Connection Lost
56 Std Parallel Port Disabled
56 Parallel Port
x
Disabled
56 Serial
x
Port Disabled
61 Defective Disk
62 Disk Full
63 Unformatted Disk
80 Scheduled Maintenance
Print Jobs on Disk?
If one of these errors occurs and Auto Continue is
disabled, the printer stops and waits for
operator intervention. When Auto Continue
is set to a numerical value, the printer waits for
operator intervention for the specified length of time and then automatically resumes
processing.
The Auto Continue value has one other purpose. If the operator panel has displayed menu
information for the specified period of time without a button being pressed, the printer
automatically exits the menus and returns to the ready state.
Jam Recovery On
Off
Auto*
When Jam Recovery is set Off, the printer does not reprint a page that has jammed.
When
Jam Recovery is set On, the printer keeps the image for a printed page until the printer
signals that the page has successfully exited the printer. The printer reprints all jammed
pages.
If Jam Recovery is set to Auto, the printer keeps the image and reprints the page unless the
memory required to hold the page is needed for other printer tasks.
Setup Menu (continued)
Menu item Values
*Factory default