Filter
Top Products
Chapter 7 Disk Array Configuration Setting
IV-39
(5) Specifying the way of binding the logical disks
Clicking the [Next] button on the “Free Area Selection” screen displays the “Binding Method” screen.
This screen is displayed when you select a pool without multiple unused areas or dynamic pool and click the
[Next] button on the “Pool Selection” screen.
Figure 7-34 Specifying the Way of Binding the Logical Disks
Specify one of the following ways of binding the logical disks:
y Only specify the number of LDs (default)
Specify the number of logical disks to bind in the pool.
y Only specify LD capacity
Specify the capacity of each of the logical disks to bind in the pool. You can specify a recommended
capacity, set the capacity same with that of a logical disk already bound, or directly designate any value for
the capacity.
y Specify both the number of LDs and LD capacity
Specify any desired values for the number of logical disks and the capacity of one logical disk.
To bind a control volume, check this option.