Filter
Top Products
Chapter 9 Configuration Setting (Common to All Units)
IV-180
failure(DDR license locked): Failed, because the DynamicDataReplication license is not canceled.
failure(DDR not supported): Failed, because the DynamicDataReplication is not supported.
failure(Disk array not exist): Failed, because the disk array does not exist.
failure(DR not supported): Failed, because RemoteDataReplication/DisasterRecovery is not supported.
failure(DR license locked): Failed, because the RemoteDataReplication/DisasterRecovery license is not
canceled.
failure(Freeze): Failed, because the disk array is freezing.
failure(invalid): Failed, because the description of the batch setup file is invalid.
failure(LINK path): Failed, because all link paths between units are faulty.
failure(MV is dRV): Failed in paring the DDR, because the MV is already the RV of the DDR.
failure(MV is freeze): Failed, because the MV is freezing.
failure(MV is LV): Failed, because the MV is classified as LV.
failure(MV is monitoring stop): Failed, because the MV is monitoring stop.
failure(MV is reserved vol): Failed, because the MV is a reserve group.
failure(MV is SDV): Failed, because the MV is classified as SDV.
failure(MV is SV): Failed, because the MV is classified as SV.
failure(MV not exist): Failed, because the volume (MV) does not exist.
failure(MV not managed): Failed, because the MV is not managed.
failure(MV not pair): Failed, because the volume is not paired.
failure(MV not primary vol): Failed, because the specified MV is not a PV (MV).
failure(MV not RDR): Failed, because the specified MV is not RDR-paired.
failure(monitoring stop): Failed, because the disk array is monitoring stop.
failure(not link): Failed, because the disk arrays of the MV and RV are not linked.
failure(not separated): Failed, because the status is not separated.
failure(not managed): Failed, because the disk array is not managed.
failure(Pair loop): Failed, because the pair layer will serve as a loop.
failure(Pair over): Failed, because the MV cannot accept pair setting any more.
failure(RDR license locked): Failed, because the RemoteDataReplication license is not canceled.
failure(RDR not supported): Failed, because the RemoteDataReplication is not supported.
failure(RV is BV): Failed, because the RV is classified as BV.
failure(RV is DDR MV): Failed, because the RV is already the MV of the DDR.
failure(RV is freeze): Failed, because the RV is freezing.
failure(RV is LV): Failed, because the RV is classified as LV.
failure(RV is monitoring stop): Failed, because the RV is monitoring stop.
failure(RV is reserved vol): Failed, because the RV is a reserve group.
failure(RV is SDV): Failed, because the RV is classified as SDV.
failure(RV is SV): Failed, because the RV is classified as SV.
failure(RV not exist): Failed, because the volume (RV) does not exist.
failure(RV registered ATgroup): Failed, because the RV is already registered with an ATgroup.
failure(several same ATgroups): Failed, because there are multiple ATgroups.
failure(different diskarray(RV)): Failed, because the pair setting does not correspond to the RDR pair that is
already registered with the ATgroup.
failure(same name): Failed, because the same ATgroup name already exists.