Filter
Top Products
Chapter 7 Disk Array Configuration Setting
IV-69
(5)-1 Specifying the number of logical disks
Check-marking on [Only specify the number of LDs] on the “Binding Method” screen and clicking the [Next]
button displays the “Specify Number of LDs” screen.
Figure 7-61 Specifying the Number of Logical Disks
Number of LDs: Specify the number of logical disks to bind.
The capacity of each logical disk is set in the unit of 1 GB, and the maximum available
capacity for the logical disks is automatically calculated. In addition to that, there is the
number of logical disks to bind in one pool, thus the number of logical disks actually
bound is the specified number multiplied by the number of pools.
[Next] button: Displays the “Setting Detail Parameter for LD Binding” screen.
[Back] button: Displays back the “Binding Method” screen.
[Cancel] button: Displays a confirmation to ask whether you want to quit the wizard, then the wizard closes
if agreed.