Filter
Top Products
Chapter 7 Disk Array Configuration Setting
IV-77
For example, when logical disk numbers 0, 1, 3, and 4 are in use, new logical disks are
numbered as follows:
When omitted: 5,6,7...
When 0 specified: 2,5,6...
When 10 specified: 10,11,12...
[Change] button: Displays the screen which allows changing parameters. (Refer to Figure 7-66 “Change
Parameter Screen”.)
[Next] button: Displays a message asking you to proceed.
[Back] button: Displays back the “Specify Number of LDs”, “Specify the Capacity”, or “Specify Number
of LDs and LD Capacity” screen
[Cancel] button: Displays a confirmation to ask whether you want to quit the wizard, then the wizard closes
if agreed.
Clicking the [Change] button on the “Setting Detail Parameter for LD Binding” screen displays the following
screen: