Filter
Top Products
Appendix F Batch Setup File
37
(H) New Port Name
Sets the names for the ports in the target disk array ((C) above) described before describing
this parameter. Describes “mmh-ssh (mm: director number in two hexadecimal digits; ss:
port number in two hexadecimal digits)” as the ID information of the ports. Describes the
newly set port name to continue from “, (comma)”.
Describing a name in excess of 32 characters for the new port name will end in error.
When making settings for other ports in the same disk array, describe the information to be
set in the same format on the succeeding line.
[An example of the user definition file for batch setting in initial introduction]
rmon name list
[array]
3000000000000003,Array001 Set the disk array name of
3000000000000003 to Array001.
The following indicate the name
settings for this disk array.
[ld]
0000h,WN,DBmaster001 Set the format of the LD number
0000h to WN, and the LD name to
DBmaster001.
The same applies to the following.
0001h,WN,DBmaster002
0002h,NX,DBmaster003
0003h,NX,DBmaster004
0004h,NX,DBmaster005
0005h,WN,DBmaster006
0006h,WN,DBmaster007
0007h,NX,DBmaster008
[port]
04h-00h,DBServer01 Set the port name of the port
number 04-001 to DBServer01.
04h-01h,DBServer02 The same applies to the following.
06h-00h,DBServer03
06h-01h,DBServer04