Filter
Top Products
Chapter 8 Disk Array Configuration Setting (S100/S1100/S1200/S1300/S2100/S2200/S2300)
IV-130
(7) Result screen
When LD Batch Binding is completed successfully, a message box as shown below appears.
Figure 8-25 Success Message Box
“Bind” here means that LD binding started successfully. Check the LD state for information by using the main
screen of the iSM client to see if the actual binding is completed or not.
Immediately after the binding is started, “Attn.(formatting)” appears as shown in Figure 8-26.
Figure 8-26 LD Formatting Screen
Even during LD formatting, it is possible to unbind LDs. Therefore, even after LD Batch Binding can be
performed again without waiting for completion of an error binding.
The LD Format Time is set to 0 hours. To change this format time, use “Change Format Time” on 8.2.3 “Setting
Logical Disk Bind Time”.