Filter
Top Products
Chapter 8 Disk Array Configuration Setting (S100/S1100/S1200/S1300/S2100/S2200/S2300)
IV-131
When LD Batch Binding fails, a message box appears as shown below.
Figure 8-27 Failure Message Box
Possible causes of an LD batch binding failure may be a communication error between the iSM server and the
iSM client, a problem in the disk array, and so forth. When there is a communication error, the binding
instruction may have been correct; therefore, reconnect the iSM client and check the state. If the disk array is in
error, the failure factor is recorded in the application log of the iSM server. In this case, take appropriate
measures while referring to the application log of the iSM server and then re-execute the binding.