Filter
Top Products
Man-Machine E1 maintenance interface software 297
Command
Description
DP Display Performance. Displays performance counters for the current hour.
D S(P)
Display Status. Displays carrier status, including alarm state and, if active, alarm
level. (Momentarily stop the scrolling display by typing P. Continue scrolling by
typing any other key.)
Hor? Help. Displays the Help screen.
L Login. Logs into the MMI terminal in a single-LEI system.
Lxx Login. Logs into the MMI terminal in a daisy-chained system, where xx represents
the address of the card to be configured.
Q
Quit. Logs out of the MMI terminal.
Note: If it is a daisy-chained system, be certain to log out when finished with
configuration. In a daisy-chained system, only one card can occupy the bus at a
given time and all other LEIs cannot notify the MMI of alarms unless logged-out
of configuration mode.
SA
Set Alarm. Sets alarm parameters, such as the allowable bit-errors per second,
threshold, and alarm duration.
SC
Set Clearing. Sets the alarm self-clearing function, "enable" or "disable."
SD
Set Date. Sets the date or verifies the current date.
SM
Set Mode. Sets the A/B Bits mode.
SS
Set Simple. Sets whether or not the LEI waits for the terminal equipment to return
an idle-state message before returning the channel to idle at call disconnect
from the far-end.
ST
Set Time. Sets the time or verifies current time.
T Test. Initiates the E1 carrier test function. To terminate a test in-process, enter
the STOP TEST command at any time.
Configuring parameters
The MMI has been designed with default settings so that no configuration is
necessary. However, it can be configured based on the call environment.
Set Time
Before beginning to configure the MMI, login to the system and verify the
current time. Do this by entering the Set Time (S T) command. The
MMI displays the time it has registered. Enter a new time or hit Enter to
leave it unchanged. The time is entered in the "hh:mm:ss," the 24-hour, or
military, format.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23 May 2008
Copyright © 2003-2008, Nortel Networks
.