Filter
Top Products
102 Chapter 14 Troubleshooting
P0919417 02.2
I forgot my mailbox password
A forgotten password cannot be recovered. Your old password must be reset to the default
password of four zeroes (0000). After the System Administrator resets your password, you must
open your mailbox and change the default password.
My mailbox is locked
Your mailbox is locked if you attempt to access your mailbox and you hear the recording: “This
mailbox has been locked to prevent unauthorized access. Please contact your administrator for
assistance.”
Your mailbox is assigned a maximum number of incorrect password attempts. CallPilot records
the number of incorrect attempts from the last time your mailbox was successfully accessed. If the
number is exceeded you are locked out. You cannot open your mailbox until the System
Administrator resets the password.
CallPilot Timeout
The Timeout feature allows five seconds for you to choose an option. If CallPilot does not detect a
selection, it replays the option list. If an option is still not selected, CallPilot ends the session.
CallPilot has minimum voice level detection. If CallPilot does not detect an audio signal, it
requests the caller to speak louder and provides the option to re-record. If no voice level is detected
after the prompt, CallPilot ends the session.
Messages are cut off
If people need to leave long messages in your mailbox (up to 10 minutes), you can ask the System
Administrator to give you more message recording storage space.
My mailbox is full
You know that your mailbox is full if you attempt to listen to your messages and you hear the
message, “Your mailbox is full. You must erase some messages before you can listen to new
messages.”
Your mailbox is equipped with the Never Full Mailbox feature, which lets a caller leave a message
in your mailbox, even if the mailbox is “full”. The message is stored, but you cannot access it until
you delete at least one saved message. If you find that you need more message time in your
mailbox, ask your System Administrator to give you more storage space.
The wrong prompt language appears on the display of my phone
If the wrong language appears on the display of your phone, notify the System Administrator.
Outbound Transfer does not work
Ensure that you have recorded the correct instructions for callers in your personal greeting. In your
greeting, tell callers to press
‡
if you use the Norstar Voice Mail interface, or
·
if you use the
CallPilot interface, to reach you. Refer to “About Outbound Transfer” on page 66 for information.