Panasonic MDDDT3530 Power Supply User Manual


 
- 57 -
How to improve the response further
You can manually adjust the 2nd gain.
With the 2nd gain adjustment, you can expect quicker response.
<Example>
When you want to reduce the noise produced during the stopping (servo-locking), you
set the lower gain after the motor stops.
<Notes> For setting parameters for other control modes, see Appendix.
Action
Status
Gain
Suppress
the vibration by
lowering the gain
Stop
(servo-lock)
Lower gain
(1st gain)
Lower gain
(1st gain)
Higher gain
(2nd gain)
1ms 2ms
Stop
(servo-lock)
Run
Time
Commanded
speed
Preparations and Adjustments
Concept of adjustment
OK, if there is no unusual running noise at servo lock in
stop. If unusual noise is found, make the value smaller.
OK, if there is no problem with the motion. With a smaller
value, responsibility improves. With an excessively small
value, oscillation occurs.
Fixed set-up
OK, if there is no unusual running noise at servo lock in
stop. If unusual noise is found, change the value.
OK, if there is no problem with the motion. With a larger
value, responsibility improves. With an excessively large
value, oscillation occurs.
OK, if there is no unusual running noise. If unusual noise
is found, make the value smaller.
First, make the set-up correctly.
Fixed set-up
OK, if there is no unusual running noise. If unusual noise is
found, change the value.
Parameter No.
Pr10
Pr11
Pr12
Pr13
Pr14
Pr18
Pr19
Pr20
Pr30
Pr31
Pr1A
Pr1B
Pr1C
Parameter description
1st position loop gain
1st velocity loop gain
1st velocity loop
integration time constant
1st velocity detection filter
1st torque filter time
constant
2nd position loop gain
2nd position loop gain
Inertia ratio
2nd gain operation set-up
Position control changeover mode
2nd velocity loop
integration time constant
2nd velocity detection filter
2nd torque filter time
constant
Guidance value
Value same as the 2nd
position loop gain
Value same as the
2nd velocity loop gain
50
0
Value same as the
2nd torque filter time
constant
50
30
1
7
1000
0
50