Filter
Top Products
56
■ Operation End (Logout)
You need to log out of the system:
•When finishing operations and powering off
•When changing an operator
● WV-CU950/650
During the login status, press the LOGOUT button while
holding down the SHIFT button.
The LCD returns to the login standby display.
● WV-CU360C/CJ
During the login status, press the LOG OUT button while
holding down the SHIFT button.
The LCD returns to the login standby display.
■ Operation Start/End (Auto
Login/Logout)
• To activate auto login or auto logout, the setting is
required in advance.
• The auto login and auto logout settings is performed in
"Controller" – "Auto Login/Logout" of WJ-SX650 Series
Administrator Console.
• Auto login and auto logout are set for each DATA port.
Operators logging into the system from the same DATA
port have the common setting.
•When both auto login and auto logout are set for a
DATA port, system controllers connected to the port
perform login and logout automatically. Then, the sys-
tem controller returns to the status before monitor selec-
tion.
■ Power-on/off
1. To power on the unit, press the power switch behind
the front panel.
2. Power on system controllers and recorders. (Refer to
the operating instructions of each system device for
how to power on.)
3. When finishing operations, power off each device in the
same procedure as power on.
■ Operation Start (Login)
By logging into the system as a registered operator, you
can control system devices with the authority of that opera-
tor.
1. Turn on the power. (Refer to Power-on/off.)
2. Wait until the login standby display appears.
<WV-CU950/650> <WV-CU360C/360CJ>
Note: If the password is wrong or no operation has been
performed for 5 seconds or more, the LCD display will
return to the login standby display.
3. Enter the user ID by pressing numeric buttons, and
press the CAM (SET) button.
4. Enter the password by pressing numeric buttons, and
press the CAM (SET) button.
<WV-CU950/650> <WV-CU360C/360CJ>
The system controller will enter the login status, and the
LCD display will become the default status.
Ｍｏｎ-- Ｃａｍ---