Filter
Top Products
Polycom® RSS™ 4000 User Guide
5-3
# reset password
Password has been successfully reset.
Show system information
Enter “show" after the prompt "#" and press Enter to display system
information including system performance, software version, PHP version,
image version, Apache version and LAN address.
IP settings
Enter the command in below format after the prompt "#" to set LAN 1 IP
address:
set lan1 static <ip address> netmask <ip mask> [gw <gateway address>]
For example, set the IP address of the LAN1 interface to 172.21.103.129,
subnet mask to 255.255.255.0, and the gateway address to 172.21.103.254:
# set lan1 static 172.21.103.129 netmask 255.255.255.0 gw
172.21.103.254
Telnet settings
Enter "telnet on" or "telnet off" after the prompt "#" and press Enter to enable
or disable Telnet.
Entering "telnet off" disables the Polycom® RSS™ 4000's telnet function. The
user can now only use the serial port to perform system setting tasks.
# telnet on
Set Telnet ON ok
Entering "telnet off" disables the Polycom® RSS™ 4000's telnet function. The
user can now only use the serial port to perform system setting tasks.
# telnet off
Set Telnet OFF ok
FTP settings
Enter "ftp on" or "ftp off" after the prompt "#" and press Enter to enable or
disable the FTP function.
Entering "ftp on" enables the Polycom® RSS™ 4000's FTP functions. Those
users defined on the Polycom® RSS™ 4000 can now use the FTP protocol to
download video files on the device.
# ftp on
Ftp service enabled. You need restart media service to make it
valid.
Entering "ftp off" disables the FTP function.
# ftp off
Ftp service disabled. You need restart media service to make it
invalid.
Cleankey
This command is used to inactivate the Polycom® RSS™ 4000. Enter