Filter
Top Products
6–31Programming
Download a Language
ASCII Hex Decimal
P–Series SFCC
V
SFCC 56 SFCC 86
Serial ESC V
1B 56
27 86
Purpose Allows
you to define and download a character substitution table and
place it within
the 224 printable symbol code points.
Expression SFCC V is followed by ASCII characters:
{QQQ}E{AAA}E{SSSSS}E
NOTE:
Each parameter is visually separated by pair
ed brace symbols for clarity in distin
-
guishing
parameters. Do not
input these brace pairs in the command sequence.
where E is the terminator following each numeric field.
{QQQ}
represents
the decimal value between 0 and 255 identifying the number of
entries
in the substitution table.
No leading zeros are required for one– and two–dig
-
it entries. Each entry consists of:
{AAA},
representing the decimal value between 0 and 255 identifying the ad
-
dress code that will cause the substituted character to print. No leading
zeros
are required for one– and two–digit entries.
{SSSSS},
representing the decimal value between 0 and 65535 identifying
the
symbol
point in the
Printronix
standard Character Library (page 9–4). No lead
-
ing zeros are required for less than five–digit entries.
Comment The
character substitution table is valid only for the current base
character set. Y
ou
cannot
access the character substitution table from
within another character set or
after changes have been made to the current character set. You can substitute any
symbol within the Character Library (page 9–4) into any printable symbol code
point.
If
{AAA} is the same value as a control character
, the control character takes prece
-
dence,
and printing of that value does not occur
. If the Space (20 hex) is
substituted,
unexpected
results may occur, including decreased print speed.
Once
defined and downloaded by
this control code, you can save the table created
by
this control code into printer power–up configuration and selected from the host
interface
or the control panel. When selected from the host,
Download a Language
is
accessed using SFCC RX (Character Set Select: International Languages). When
selected via control panel, the message display reads “DOWNLOADED,” and a
configuration printout reads DOWNLOADED in the international language sec-
tion of the printout.