Filter
Top Products
Configuration3–2
From
the main configuration menus below
, related configuration parameter values can be displayed
and
selected.
• Character Set
• Application Compatibility
• Paper Format
• Host Interface
• Load Parameters
• Save Parameters
• Diagnostics
Once
the ENTER switch is unlocked, displayed values can be selected as the current configuration by
displaying
the value in the message display and pressing ENTER. Y
ou can exit from a configuration
menu by pressing CLEAR, which places the printer off line.
NOTE:
If an “E” is displayed in the upper right corner of the LCD, the VFU is enabled. If a
“L”
is displayed in the lower right corner of the LCD, the VFU is loaded.
Configuration Printout
The
configuration printout lists all of the currently selected configuration parameter
values. A sample
configuration
printout is shown in
Figure 3–1. Configuration parameters on the printout are listed in
the same order as the configuration menu via control panel.
The
following general procedure is used to obtain a
configuration printout. Refer to the Control Panel
Configuration
Diagram beginning on page 3–7 for an illustration of
the available menus and values.
When
you return to OFFLINE READY
, the previous print mode and LPI is restored, and all print at
-
tributes are canceled. All other format parameters are unaffected.
1. Place the printer off line.
2. Select
and display the CONFIGURA
TION PRINT
OUT menu in the DIAGNOSTICS menu by
pressing
MENU DOWN and then PREV V
ALUE until DIAGNOSTICS appears
in the message
area.
3. Press
MENU DOWN to display CONFIGURA
TION PRINT
OUT in the message area.
4. Press R/S. The configuration printout prints.
5. Press CLEAR to return to OFFLINE READY.
6. Place the printer on line.