Filter
Top Products
Installation10–8
Preliminary Test
After
installation, the
printer is ready for preliminary testing. The following steps define the test proce
-
dure. Refer to the Operation chapter for a description of the control panel and message display.
1. Set the AC power switch to ON (|).
2. Load full–width (132 columns) computer paper and ribbon as described in the Loading Paper
and Loading the Ribbon sections of the Operation chapter.
3. Set top–of–form as described in the Setting Top–of–Form section of the Operation chapter.
4. If
the printer is on line, press the ON LINE switch until the display shows OFFLINE READY
.
5. Press and hold the PAPER ADV switch. The paper advances to the next top–of–form.
6. Press
the MENU DOWN switch, then repeatedly press the NEXT switch until the DIAGNOS
-
TICS
menu appears on the display
.
7. Press the MENU DOWN switch, then repeatedly press the NEXT switch until the PRINTER
TEST FULL WIDTH menu appears on the display.
8. Press the MENU DOWN switch, then repeatedly press the NEXT switch until the PRINTER
TEST
SHIFT RECYCLE message appears on the display
.
9. Press
the
R/S switch. The RUNNING TEST SHIFT RECYCLE message appears. Shifted lines
of the character set will print across the full width of the paper (132 characters).
10. T
o stop the test, press the R/S switch.
11.
Press
CLEAR to return the printer to OFFLINE READY.
Examine the print quality. The characters should be fully formed and of uniform density. If the test
does not run or characters appear malformed, contact your authorized service representative.