Filter
Top Products
2–17Operation
5.
When the desired print mode is shown on the display
, press the ENTER switch.
6. Press CLEAR to return the printer to off line status. The display reads OFFLINE READY.
7. Simultaneously press MENU UP and MENU DOWN to lock the printer configuration.
8. Close the printer cover and place the printer on line.
For additional printing capabilities and character attributes, refer to the Programming chapter. Print
mode control from the host overrides the control panel setting.
Setting Line Spacing
P3040
Multinational printers can be set for a line spacing of 6, 8, or 10.3 lines per inch (lpi) from the
control
panel by using the 6/8
LPI switch. T
o select the line spacing from the control panel, perform the
following
steps.
1. Place the printer off line and raise the printer cover.
2. Press 6/8 LPI. The currently selected lpi setting displays.
3. Press
NEXT
, PREV
, or 6/8 LPI to step
through the 6, 8, and 10.3 lines–per–inch selections. The
light
beside the 6/8 LPI switch lights when the selected line spacing is other than 6 lpi.
4. Press
CLEAR when the
desired line spacing setting is displayed. The printer is placed of
f line and
the display reads OFFLINE READY.
5. Close the printer cover and place the printer on line.
Line
spacing can also be selected by sending line spacing control codes from the host computer as
de
-
scribed
in the Programming chapter
. Using control codes, the host computer can specify line spacing
other than 6, 8, or 10.3 lpi. Line spacing control from the host computer overrides the control panel
setting.
Printer Reset
This
function resets the printer to the configuration values
last saved
(not factory default values), and
the
current form position becomes the top–of–form. The printer
can be reset to the power–up configu
-
ration
values at any time: on
line, of
f line, or while printing. However
, it is recommended that you reset
the printer only when it is off line to prevent the possible loss of data. The printer can also be reset
through the host. (Refer to the Programming chapter.)
To reset the printer
, press CLEAR and RUN/ST
OP (R/S) simultaneously.
IMPORTANT
Information regarding Hex Code Printout, Running the Self–Test, and Fault
Condition Messages is located in the Routine Service and Diagnostics chapter.