Filter
Top Products
Configuration3–4
Factory Default Configuration Values
The printer comes with a set of Printronix factory configuration values, shown in Table 3–1. These
values
are set at the factory
, and are operational when the printer is received. New values can be saved
and
applied as necessary for each application, but factory default values remain accessible using the
LOAD
P
ARAMETERS configuration. On
the Control Panel Configuration Diagram, factory configu
-
ration
values are indicated
by a asterisk (
*
). (The asterisk is not shown on the printer display
.) Refer to
the
Configuration Procedure on page 3–5 to change values of the configuration parameters for your
application.
Table 3–1. Printronix Factory Default Configuration Values
Forms Length
Print Mode
Line Spacing
Printer Protocol
Auto Line Feed
VFU Select
PMD Fault
Perforation Skip
Paper Empty
Configuration Factory Default
Parameter Value
11.0 Inches
DP 10 cpi
6 lpi
P–Series
After Full Line
EVFU
Enable
00.0 Inch
End of Paper
Printer Select Disable
Define CR Code CR = CR
Paper Advance Switch PRINT + PAP ADV
Power On State Online
Parallel Interfaces:
Data Bit 8
Data Polarity
Latch Data On
Strobe Polarity
Enable
Standard
Leading Edge
Standard
Serial RS–232 Interface:
Data Protocol
Data Rate
Word Length
Stop Bit
Parity
Bit 8 Function
CD
AND CTS
Request to Send
Data Term Ready
X–On / X–Off
9600 Baud
8 Bits
One
None
Font Select
Disable
Online and BNF
Online and BNF
Resp. Polarity Standard
PI Line Disable
Reverse Channel
DSR
Online and BNF
Disable
Define LF Code LF = CR + LF
Alarm On Fault Enable
Unidirectional Disable
Configuration Factory Default
Parameter Value
Select Subset
Select Set
ASCII
IBM PC
Select Language
IBM PC Graphics
Select SFCC 01 SOH
Control Code 08 Double High
80–9F Hex Control Codes
Overstrike Enable
Print Width 13.2 Inches
Control Code 06 8 lpi
CentronicsHost Interface