Filter
Top Products
Configuration3–6
Load Configuration Values
The
previously saved default value
set or the permanently stored
Printronix
factory value set can be
loaded
for use as needed. This procedure
provides a convenient method of resetting the printer con
-
figuration
to a known value set.
1. Place
the printer of
f line by pressing ON LINE. Enable the ENTER switch by pressing MENU
UP
and MENU DOWN simultaneously
. ENTER
SWITCH NOT LOCKED temporarily appears
in
the message area.
2. Select
and display
the LOAD P
ARAMETERS main menu by pressing MENU DOWN and then
NEXT or PREV VALUE.
3. Press
MENU DOWN and then NEXT or PREV V
ALUE to select either the LOAD SA
VED P
A-
RAMETERS
or LOAD F
ACTOR
Y P
ARAMETERS menu. If
an IGP
, IBM 3287, or IBM 5225
emulation board is installed, select the appropriate standard configuration listed in this menu.
4. Press
ENTER once the desired selection is shown in the message display
. The display then reads
LOAD SAVED COMPLETED or LOAD FACTORY COMPLETED.
5. After all parameters have been changed as required, select the SAVE PARAMETERS main
menu
and press ENTER. This saves the current parameter values as the default values.
6. Press CLEAR to return to OFFLINE READY.
7. Disable the ENTER switch by pressing MENU UP
and MENU DOWN simultaneously
. Place
the printer on line by pressing ON LINE.