Filter
Top Products
Programming6–62
Skip–Over Perforation
ASCII Hex Decimal
P–Series N/A N/A N/A
Serial ESC N n 1B 4E n 27 78 n
Purpose Selects
the number of lines (at the
current line spacing) for the paper “skip” at the
bottom of the perforated page.
where n = 1 to 127 to select the number of lines to skip. If the value of n exceeds the
current forms length, it is ignored.
Comment The
actual distance set is the product of
n
and the
current line spacing. The factory
default
value is to disable skip–over perforation. Y
ou can specify the default value.
Setting a new forms length (ESC C) resets skip–over perforation to zero.
This feature is disabled whenever vertical tabs are set.
You
can also select skip–over perforation from
the control panel; however
, vertical
tabs
within the skip–over perforation zone, as
set by the control panel, are ignored.
The
control code
skip–over perforation setting from the host computer overrides the
control
panel setting.