Filter
Top Products
Installation10–4
Shipping Restraints
During
shipping, the printer mechanism is protected by foam packing, restraint bolts, and a
removable
tie
wrap securing the Forms Thickness Adjustment Lever
. Remove the shipping
restraints as described
below and illustrated in Figure 10–3.
CAUTION
To avoid shipping damage, reinstall the shipping restraints whenever the printer is
moved or shipped.
VORSICHT
Um Versandschäden zu verhindern, die Versand–Einspannungen wieder einbauen,
wenn
der Drucker versetzt oder versandt wird.
Shipping Restraint Removal
WARNING
To
pr
event possible injury
, do not connect
the AC power sour
ce befor
e r
emoving the
shipping
r
estraints. If the power sour
ce has alr
eady been connected, disconnect it be
-
fore performing the shipping restraint removal procedures.
WARNUNG
Um mögliche Verletzungen zu vermeiden, darf die Netzverbindung erst nach dem
Entfernen
der T
ransportbefestigungen hergestellt werden. Falls
die Netz verbindung
bereits
hergesfellt wurde, ist diese zu unterbr
echen bevor die T
ransport befestigun
-
gen entfernt werden.
1. Raise the printer cover.
2. Loosen the captive screws (A) securing the shuttle cover (B).
3. Lift the shuttle cover (B) up and out of the slots at the front.
4. Remove
the two red–capped transport restraint bolts (C) by hand. Place the bolts in the storage
slot on the left side of the printer base (pedestal models; right side in floor cabinet models).
NOTE:
The r
estraining bolts must be r
einstalled whenever the printer or shuttle assembly
itself
is shipped or transported.
5. Remove the tie wrap securing the Forms Thickness Adjustment Lever (D).
6. Lift
the shuttle release lever (E), rotate the shuttle assembly upward (to its service position), and
remove the foam pad (F). Lower the shuttle assembly back into print position.
7. Replace
the shuttle cover (B) with the tabs sliding into the slots at the front. If you do not properly
replace
the cover
, an error condition will show on the display
when you try to operate the printer
.
8. Retighten
the captive screws (A) to secure the shuttle cover
.