Filter
Top Products
2–9Operation
Loading Paper
The
printer uses standard fanfold paper from 3 to 16 inches wide (perforation
to perforation) and 15 to
100
lb. bond (0.025 inches thick maximum). T
o load paper
, perform the following steps and refer to
Figure 2–3.
1. Place the printer off line and raise the printer cover.
2. Fully raise the Forms Thickness Adjustment Lever (A).
3. Open both tractor gates (B) by swinging them out.
4. Feed
the paper up
through the paper slot at the base of the printer
. (In floor cabinet models, open
the front printer door and align the paper supply with the position of the tractor sprockets (D).
Feed
the paper up through the paper slot until it appears above the ribbon mask (C). If the paper
snags, fold the top edge down before feeding.
5. Load
the paper on the tractor sprockets (D); close the tractor gates (B). If necessary
,
slide the right
tractor
to remove paper slack or to adjust for various paper widths by releasing the right
tractor
lock
(E) by raising or lowering it to the center; slide the tractor into position. After positioning the
tractor, lock it in place.
NOTE:
Lock the left tractor in alignment with the number “1” on the
paper scale to set the
left
mar
gin with the first character space.
6. Continue to feed the paper through the paper path at the top of the cabinet (F).
7. For
printers with a Quick Access cover
,
close the printer cover
. Open the plastic Quick Access
cover by pulling the Quick Access lever located on the
right
side of the printer
. Feed the paper
through
the clear plastic Quick Access cover
.
8. Press PAPER ADV to advance paper into the paper stacking area. Verify unobstructed paper
feeding.
9. Set the Forms Thickness Adjustment Lever (A) with slight friction to approximate the paper
thickness.
The A–B–C scale indicates relative positioning to correspond approximately with 1–
to 6–part paper thicknesses. (If closed too tightly, the shuttle may stall or tear the paper.)
10. Set the top–of–form as described in the Setting Top–of–Form procedure on page 2–12.
11. Close the printer cover.
12. Press CLEAR and place the printer on line.
NOTE: The P3040 is the pedestal model illustrated thr
oughout this manual.