Filter
Top Products
Operation2–12
Figure 2–4. Ribbon Replacement
8. Press CLEAR (on the control panel) to clear the PLATEN OPEN fault condition.
9. Close the top cover and place the printer on line.
Setting Top–Of–Form
Top–of–form
determines where the first line of print will appear and is set when paper is loaded. T
ypi-
cally,
the first line of print is set approximately one–half
inch below the paper perforation unless spe
-
cific application requirements dictate otherwise.
Once
top–of–form has been set, press and hold the P
APER ADV switch to advance to the top of
the
next form. Unless otherwise configured, the
printer assumes 1
1–inch length paper is used. For alter
-
nate length forms, refer to Setting Forms Length on page 2–15.